Welch Allyn SCANTEAM 5770 LASER Spezifikationen Seite 5

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 12
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 4
3
Proper Disposal of the Battery Pack
When the battery pack has reached the end of its useful life,
the batteries should be disposed of by a qualified recycler or
hazardous materials handler. Do not incinerate the battery
pack or dispose of the battery pack with general waste
materials. Contact the Product Service Department (see page
5) for recycling or disposal information.
Charging Your Battery Pack
Charge the battery pack by following the steps below:
1. Fully charge the battery (see page
2). Plug the battery pack directly
into any common 120 V AC outlet
in North America. If outside North
America, use the custom charge
strip.
2. The LED on the bottom of the bat-
tery pack lights red when the unit is
charging; it shows green when it is
fully charged and ready to use.
Note: It is important that you charge
the battery for 24 hours prior to
first use. No damage occurs if
this is not done, but the battery
capacity will not be at 100%.
(Fully discharge in between
each initial charge.)
Recharge Time: 6 hours at any
voltage at 20
°
C (68
°
F.)
3. After the battery pack is fully
charged, attach it to the cordless
scanner by pressing the pack firmly (align the prongs on the pack with the
mating receptacles) in the base of the scanner until the release buttons click,
holding the pack firmly in place. (
When you attach a charged battery pack to
the Cordless Scanner, you will hear a single beep
.)
4. If you have not set up your Cordless System, refer to Setting Up and Con-
necting the Cordless System section in the System Manual for instructions.
When the battery pack needs recharging, the yellow LED on top of the scanner
gives 3 short pulses. You will still be able to use the scanner; however eventually
the LED will flash 3 times and the scanner will not scan. If the LED stops flashing
when the temperature lowers or you do not use the battery pack for some time,
you still need to charge the battery pack to avoid damaging the battery pack or
causing scanner memory loss.
Seitenansicht 4
1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare