Welch Allyn MicroTymp 3 Handle Betriebsanleitung PDF herunterladen (Seite 52)

Paper Replacement

The MicroTymp2 Printer/Charger signals the need for changing the paper in

one of two ways:

• A pink strip appears along the edge of the paper indicating the paper is

nearing the end of the roll.

• The POWER

indicator flashes in single pulses indicating that there is

no paper, and no printing can occur.

NOTE:

• Use only an appropriate heat-sensitive paper or the Printer/

Charger life may be shortened and the warranty voided.

• The paper is thermally activated, so it must be stored in a

cool, dark location to prevent exposure and degraded

performance.

• Because the paper is thermally activated, no printing will

appear on the paper if it is inserted backwards.

• Do not use transparent adhesive tape on printed portions

of the printout, as those portions will then fade.

To Replace the Paper

CAUTION: Disassembly of the Printer/Charger presents a

possible electrical-shock hazard. Refer all servicing to Welch

Allyn or a Welch Allyn authorized service representative, listed

on page E-55.

1. Remove the paper access cover by pulling up on the front edge. See

Figure 40.

Figure 40

C-48

Appendix C

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 71 72

Keine Kommentare

Welch Allyn MicroTymp 3 Handle Betriebsanleitung Seite 52