Welch-allyn LC101 CO2 Module - User Manual Bedienungsanleitung Seite 70
- Seite / 98
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
LC101 CO
2
Module OEM Implementation Manual
Page 70 Confidential Welch Allyn OEM Technologies
29, Unable to Perform Calibration, Data Error
The acquired CO
2
data is invalid or out of range for the calibration. The Module will abort the
calibration. This error also occurs when calibration is aborted due to any other non-fatal error.
2A, Bad Calibration CRC
The system EEPROM CRC is not valid after being updated with the new constants.
Sensor Faults
CO
2
sensor faults are conditions that result in shutting down the sensor. A CO
2
sensor shutdown
turns off the lamp and the pump.
To clear a sensor fault, perform a software reset followed by a new host command.
If the Module
does not accept the command, a hard reset is required.
Sensor faults are listed in the following table.
51, CO
2
Sensor Manufacturer Code Mismatch
Sensor manufacturer code stored in sensor EEPROM does not match the host monitor
manufacturer code.
•Verify the data in the EEPROM location.
Status
Message Code
(hex)
Definition Possible Causes
51 Customer code mismatch • Incorrect EEPROM data or bad sensor EEPROM
57 CO
2
sensor not found • Main Board not acknowledging the sensor
• loose or faulty sensor connection
60 CO
2
sensor EEPROM error
in revision #
• incompatible/invalid sensor EEPROM revision #
•faulty sensor EEPROM
65 CO
2
sensor EEPROM error
in read or write operation
•invalid read/write to sensor EEPROM;
•faulty sensor EEPROM
66 CO
2
sensor EEPROM error
in CCITT/CRC code
•invalid sensor EEPROM CCITT/CRC code;
•faulty sensor EEPROM
70 CO
2
sensor temperature
too high
• sensor exposure to excessive heat source;
•faulty sensor
71 CO
2
sensor temperature
too low
• sensor exposure to excessive cold source;
•faulty sensor
- LC101 CO 1
- Functional Description 7
- Terminology 8
- Measuring Principle 8
- Measurement Calculation 9
- Measurement Compensation 10
- Hardware Components 11
- Sidestream Components 13
- LC101 Module Interface 15
- Watertrap Switch Connection 16
- Watertrap Receiver 16
- Watertrap Receiver Switch 17
- Exhaust Tubing 17
- LC101 Calibration 19
- Zero Calibration Procedure 20
- Section 3 - LC101 Calibration 21
- Troubleshooting 24
- Host/Module Communications 25
- Packet Structure 26
- Host Commands 27
- Simple Commands 28
- Configuration Commands 29
- C-Cap EEPROM Memory Map 32
- Status Responses 34
- Mode Command Responses 35
- Simple Command Responses 36
- Example: 38
- Calibration Command Responses 40
- Software Protocol 41
- Status Message Code Table 44
- Code (hex) Suggested Message 44
- Fault OFF OFF NO 46
- Standby OFF OFF NO 46
- Measurement ON ON YES 46
- Autorun ON ON YES 46
- Pneumatic Operation 47
- Pneumatic Events 48
- Total Exhaust Occlusion 49
- Partial Exhaust Occlusion 49
- Barometric Out Of Range 49
- Unexpected Reverse Flow 49
- Internal Disconnects 50
- Pump Failure 51
- Regulatory 53
- Electromagnetic Interference 54
- Compliance Testing Summary 54
- ISO 9918 and EN 864 54
- Software Procedures 55
- Percent CO 56
- Calculation 56
- Seq Host Module Description 58
- CCITT/CRC Code Calculation 60
- Software Upgrade 61
- EEPROM Memory Map 63
- Error Messages & Recovery 65
- Advisories 66
- Too Large 67
- Calibration Advisories 68
- Soft Faults 69
- Sensor Faults 70
- System Faults 72
- Welch Allyn OEM Technologies 75
- Part Numbers and Accessories 75
- Technologies 76
- Specifications 77
- Appendix E - Specifications 79
- (Ref. 000.10100.UOO Rev. 0) 79
- Developer’s Kit 83
- Software Installation 84
- Initial Setup 84
- Appendix F - CO 85
- Menu Options Description 86
- 50 mmHg 6% 88
- 75 mmHg 10% 88
- 100 mmHg 14% 88
- Glossary 91
Verwandte Produkte und Handbücher für Ausrüstung Welch-allyn LC101 CO2 Module - User Manual
Ausrüstung Welch-allyn LumiView Portable Binocular Microscope - User Manu Bedienungsanleitung
(84 Seiten)
(84 Seiten)
Ausrüstung Welch-allyn AURIFLUSH Revised Cleaning/Disinfecting Chart - Us Bedienungsanleitung
(1 Seiten)
(1 Seiten)
Ausrüstung Welch-allyn SureSight Vision Screener Autorefractor - User Man Bedienungsanleitung
(32 Seiten)
(32 Seiten)
(192 Seiten)
Ausrüstung Welch-allyn LumiView Portable Binocular Microscope - User Manu Bedienungsanleitung
(1 Seiten)
(1 Seiten)
Ausrüstung Welch-allyn Lumiview Power Sources(Portable and Direct Lug-In) Bedienungsanleitung
(40 Seiten)
(40 Seiten)
Ausrüstung Welch-allyn 205084-1, Light Attached To Goggles - User Manual Bedienungsanleitung
(1 Seiten)
(1 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.036 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern