Welch Allyn PROPAQ CS Spezifikationen PDF herunterladen (Seite 45)

Directions for Use Monitoring 41

Perform SpO

“spot-check” monitoring

The SpO

Standby Mode allows you to remove the SpO

sensor from a patient without

having to disable all alarms or disconnect the SpO

sensor cable from the Propaq CS

monitor. You can therefore perform intermittent or “spot-check” SpO

monitoring.

1. While monitoring SpO

, remove the SpO

sensor from the patient, but leave it

connected to the monitor. When the monitor detects the lack of a pulsatile waveform,

it sounds a patient alarm and displays this menu:

2. Press STANDBY to place SpO

into the Standby Mode.

The monitor suspends the SpO

alarm tone indefinitely and displays STANDBY in

place of SpO

numerics. SpO

remains in the Standby Mode until the SpO

sensor is

reapplied to a patient. Other vital sign monitoring is not restricted. By contrast, if you

press SILENCE instead of STANDBY, the monitor temporarily silences all alarm

tones; however, the alarm tone resumes after 90 seconds if the SpO

sensor is still

disconnected from the patient—see “Silence an active alarm or alert tone for 90

seconds” on page 49.

3. To resume SpO

monitoring, reapply the SpO

sensor to a patient.

The monitor exits the Standby Mode and resumes SpO

monitoring.

Note

The message STBY on the SpO

trend display and trend printouts indicates the

monitor was in the SpO

Standby Mode.

SILENCE

STANDBY

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 129 130

Keine Kommentare

Welch Allyn PROPAQ CS Spezifikationen Seite 45