Welch-allyn SureTemp PlusModule - User Manual Bedienungsanleitung PDF herunterladen (Seite 31)

SureTemp Plus Module OEM Implementation Communications Protocol

Welch Allyn OEM Technologies Conﬁdential 31

Two possible approaches to changing the defaults:

• Implement a factory procedure in which the host’s ATE sets the values once and then

saves the values to the EEPROM on the module.

• During each power-up and initialization of the host device, the host sets the module

parameters in RAM and does not write them to EEPROM.

The Command and Response descriptions (page 38) contain further information.

Packet Structure

Transmission of host commands and module responses is via packets, or message blocks. All

messages are in binary format and are aligned on byte boundaries. The following structures

represent Command/Response message blocks.

Endian Format

All command blocks, response blocks, and data size are in little-endian format, least-signiﬁcant

byte ﬁrst. Command codes are in big-endian format, most-signiﬁcant byte ﬁrst.

For a brief description of endianness, with examples, see page 55.

Programmable Ambient Bias Temperature difference between ambient and the probe tip.

(Default: 0.56)

Clinical Pause The monitor continues automatically from Predictive to

Monitor mode during clinical testing. (Default: disabled)

3-byte preamble 0x03, 0x02, 0x10

2-byte command code CC-high, CC-low

1-byte type code TT-high

2-byte data size SS-low, SS-high

X bytes of response data (format depends on command)

1-byte checksum 0xYY

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 84 85

Keine Kommentare

Welch-allyn SureTemp PlusModule - User Manual Bedienungsanleitung Seite 31